阀门的安装说明（中英文）

Grit, dirt or any foreign matter accumulated in the pipe can hinder efficient valve operation and seriously damage vital valve parts. Thoroughly clean pipe internally with air or steam.

当对管道进行攻丝时，要测定管道螺纹的尺寸和长度，避免将管道塞满阀座和阀瓣。彻底清洗螺纹末端，清除任何有害的钢或铁沉淀物。如果要时焊接更牢固，就要使用特氟隆带或管道粘接剂。在管道螺纹上只能少量使用管道粘接剂，但是在阀门螺纹上绝对不能使用管道粘接剂。不要让任何管道粘接剂流入阀体内，以避免损坏阀瓣和阀座。
When threading pipe, gauge pipe threads for size and length to avoid jamming pipe against seat and disc. Thoroughly clean threaded end to remove any harmful steel or iron deposits. For a good joint, use teflon tape or pipe dope. If pipe dope is used, apply sparingly on pipe threads, never on valve threads. Do not allow any pipe dope into valve body in order to avoid damage to disc and seat.

安装前，切断通过阀门的流体，以使阀门工作正常。安装前要完全关闭阀门。将扳手套在靠近管道的六角螺栓头上避免可能产生的变形。安装阀门后，要支撑住管道：下垂的管道会使阀门产生变形而导致失败。
Before installation, check line of flow through valve so that valve will function properly. Close valve completely before installation. Apply wrench to hex next to pipe and guard against possible distortion. After installation of valve, support line; a sagging pipe line can distort valve and cause failure.

法兰连接
FLANGED

为了确保正确进行阀兰连接安装，需要遵循如下几个步骤。首先细心地清洗连接处，然后，在底座部松散地装上两个或三个螺栓。接着，小心的将垫片插入连接处。底部螺栓有助于对垫片进行定位，并保持恰当的位置。然后插入螺栓要采用交叉旋紧的方式，不要采用环绕旋紧的方式，这样有助于消除过于集中的压力）。在正常使用一段时间后，要检查核对所有的螺栓是否旋紧，并进行必要的再旋紧。
There are several steps to follow to make sure that a flanged joint will be properly assembled. First, clean the joint carefully. Then loosely assemble the joint by putting in the bottom two or three bolts. Then carefully insert the gasket into place. The bottom bolts will help locate the gasket and hold it in position. Then insert the rest of the bolts into place and tighten all of the bolts evenly—not in rotation, but by the cross-over method to load the bolts evenly and eliminate concentrated stresses. The bolts should be checked for tightness after an appropriate interval of use and retightened if necessary.